See Program Links.

Suni offers sensors and the imaging software Prof Suni and Dr. Suni. Both can be set up via the Apteryx Bridge.

We provide limited support for direct connection to Suni sensors. The 1200, 1200C, 1600, 1800 series are supported. #1 & #2 hi res are the only supported sensors. Currently, there is only a 4BW mount used for capturing. See Scanning/Imaging Defaults to set the Suni hardware options. Because of the limited mounts and lack of a ruler, the support for Suni is marginal, and very likely not ready for prime time. But it is functional.

To capture an image, click Capture in the Imaging Module.

Setup a Suni Sensor

To setup a Suni sensor for use with Royal dental Software directly copy the contents of the Suni CD that came with your sensor into the C:\Program Files\Royal dental Software\Suni\ directory. If you have more than one sensor, you must be sure to copy the contents of the CD that came with the sensor hooked up to the computer in question. You should also ensure that the drivers for your Suni sensor are up to date in the Windows hardware manager. Check these before you try anything else. It may help if you reset your Suni hardware. You can do that by unplugging the USB connection from the back of the computer and unplugging the connection to the wall socket (if there is one). Leave the device disconnected for at least 1 minute, then reconnect and try to capture again.

Royal dental Software does not currently support more than one sensor per workstation.

Also see this document: SuniSensorDocument.pdf

1/23/2014: Suni sensor models 1200, 1600, and 1800 are not compatible with Windows 7, Windows 8, or Windows 8.1 because there are no drivers available for the 32 or 64 bit versions.